Skip to content
IRON ON INSTRUCTIONS
How to Apply NIGHT VISION Iron-Ons
Prep Garment –
-
For best results, use 100% Polyester, 100% Cotton or a Cotton/Poly Blend.
-
Wash & Dry Garment.
-
If you’re unsure about your garments ability to withstand heat, test first.
-
Set the iron to high heat. (DO NOT USE STEAM).
-
Avoid placing Iron-On over areas where there is stitching.
Ironing On the Transfer –
** Make sure to use FLAT surface, perforated ironing board not recommended**
-
Trim excess plastic around the design.
-
Place the iron-on with design down, plastic film on top.
-
Iron the area for 20-30 seconds, using medium pressure while moving the iron in a circular motion. Do one section at a time, evenly, for larger transfers.
-
Allow transfer to cool for 15 seconds, then SLOWLY peel the plastic film while still warm.
-
If it has not fully transferred and is not peeling properly, put the plastic back in place and iron for another 15 seconds, or as needed.
Caring for your Iron-On –
-
Wash garment inside-out using a delicate setting, cold water, and a mild detergent.
-
Dry on low heat, or preferably hang to dry.
Peeling may occur over time, if this happens, iron the area again.